[. . . ] Read the instructions for use together with the illustrations (pages 3 and 34) before using the appliance. â· Before connecting the appliance check that the voltage indicated on the type plate corresponds to the mains voltage in your home. [. . . ] In such a case, the fuse or the circuit breaker may not be able to handle high electrical power. You may connect one of the involved appliances to another circuit (employing another fuse or circuit breaker) or have the electrical installation revised by an authorized electrician. If the mains cord of this appliance is damaged, it must only be replaced by Philips or their service representative, as special tools and/or parts are required. The warm radiator causes both a natural hot air flow (convection / heat distribution) and heat radiance (warm feeling on the skin). mounting the supports For safety: Mount the wheels before using the appliance. (It is quite normal if you can hear the oil moving inside the radiator. Wait for at least three minutes before connecting up and switching on. How to use Power setting Higher power settings result in quicker heating. ) After this, the heater will keep its environment at the set temperature by switching on and off at intervals. when a heating element has been switched on by the thermostat the pilot lamp in the corresponding switch (A) and/or (B) will illuminate. A good way of finding the ideal thermostat knob setting for you is as follows: - First set the knob to position 10 (= maximum). - As soon as the temperature is comfortable, turn down the thermostat knob slowly until the heater goes off. [. . . ] The non-rewirable plug must be cut from the mains cord, the fuse removed, and the plug safely discarded to prevent further use. The removed plug can be hazardous if inserted into a live mains socket. [. . . ]